| 盖板模具在安装过程上要首先要清理边坡, |
| 添加时间：2022/2/18 16:08:10 浏览次数： |
| 盖板模具在安装过程上要首先要清理边坡,保持平整,保障没有大的突起,再而做一些铺垫层,尽量保持平整。盖板模具具含孔材料的密度,应将材料磨成细粉,除去孔隙,干燥后,用盖板模具鉴定其实际体积。材料磨得越细,测得的密度数值就越精确。砖、石材等块状材料的密度即用此法测得。 In the process of installation, the cover plate mould should first clean the slope, keep it flat, ensure that there is no big protrusion, and then make some bedding layer to keep it flat as far as possible. The cover plate mould has the density of the porous material. The material shall be ground into fine powder, the pore shall be removed, and the actual volume shall be determined by the cover plate mould after drying. The finer the material is, the more accurate the density value is measured. The density of block materials such as brick and stone is measured by this method. 在测定某些较密实的不规则的散粒材料模具的实际密度时,常直接用排水法测其绝对体积的近似值。盖板模具具应包装严密、整洁。应严格入库验收,禁止质次或已老化变质的份子化合物塑料制品入库。应保持存放盖板模具的库房清洁、墙壁、门窗应刷上白色,制止阳光直射,同时不能同仓储放油类、腐化性及含水量大的商品。底层仓库要隔离地潮,露天货垛要做好防晒、防雨、防风、防止露垛。 When measuring the actual density of some dense irregular bulk material mould, the approximate value of absolute volume is usually measured directly by drainage method. The cover plate mould shall be packed tightly and neatly. Strictly put into the warehouse for acceptance, and prohibit the storage of plastic products of molecular compounds with quality or aging. The warehouse for the mould of cover plate shall be kept clean, walls and doors and windows shall be painted with white, and direct sunlight shall be prevented. At the same time, the goods with oil, humification and water content shall not be stored. The bottom warehouse should isolate the tide, and the open-air Cargo Stack should be sun proof, rain proof, wind proof and prevent exposed stacking. |
| 上一页 混凝土检查井是检查井种类中的一种 |
| 下一页 一般电力检查井模具都是在专业的预制厂家进行生产 |